Why is the clutch making an odd noise in my 2015 Mazda BT-50?
- Mazda BT-50
- Mazda BT-50 2015
- Mazda Advice
- Mazda BT-50 Reviews
- Mazda Commercial Range
- Mazda Ute Range
- Mazda
Asked by Wayne
The clutch makes a noise when the pedal is out and in neutral in my 2015 Mazda BT-50, what could the issue be?
Answered by CarsGuide
11 Sep 2020The most common cause of a noise like this is likely to be a worn throw-out bearing, also known as a release bearing. Like most bearings, this component is designed to allow interaction between a moving surface (in this case the clutch which is turning at engine speed) and a stationary one (the clutch fork that physically disengages the clutch when you stand on the clutch pedal).
If this bearing becomes contaminated, rusty or just plain worn out, it can begin to emit the sort of sound you’re hearing. Why doesn’t it do it when the clutch pedal is pressed? Because the springs in the clutch are loading the bearing and taking the wear (or slack) out of it. When you release the clutch, the bearing relaxes and is free to make its noise again. Sometimes the reverse is true, and depending on where precisely the wear is located, the bearing makes the most noise when it’s loaded by the clutch springs. Either way, it’s a gearbox-out job, but beyond that it’s not a difficult task for a workshop.
Other Mazda BT-50 problems
- Replacement LED headlights aren't running correctly on a 2011 Mazda BT-50 ute
- What tow vehicle or hybrid camper should I consider for after retirement?
- My Mazda BT-50 went into limp mode after normal towing
- The alternator in my 2021 Mazda BT-50 isn't fully charging the battery
- Should I repair my Mazda BT-50's solenoids?
- Circuit issues on 2013 Mazda BT-50 fuel injector
- 2008 Mazda BT-50 overheating
- Steering locking up in my 2013 Mazda BT-50
