Question 1

How to replace windscreen wiper blades in my 2012 Holden Cruze?

Accepted Answer

This shouldn’t be a difficult job and it’s a good task to ease yourself into maintaining your own vehicle. The simplest way to do this is to replace the entire blade and spine assembly. This will cost more than replacing just the rubber blade, but is very easy with just one catch to unclip (where the blade pivots on the wiper arm) before the whole assembly can be removed and replaced. You can google tutorial videos on this take which take you through the whole process. It should take only a couple of minutes. If you’re really stumped by this, some parts stores offer a free fitting service for things like wiper blades. You may have to buy a new pair of blades to access this service, however. But if you watch the process and take note of how it works, you’ll be able to change your own blades in the future.

Question 2

Engine oil is getting in the radiator of my 2016 Holden Cruze

Accepted Answer

The first conclusion many mechanics will arrive at is that the engine’s head gasket has blown, allowing the oil and coolant to mix. Have a look at the dipstick. If the engine oil is milky, then this is a very real possibility. Perhaps when the cylinder head was replaced, the gasket has not sealed properly. But if the oil cooler was replaced because it was leaking into the radiator (which is pretty common) then you might find that the oil you’re still seeing is just residual oil from the previous failure, and not a problem at all. Even so, it would be wise to replace the coolant and flush the system to try to eradicate all traces of the old oil. A workshop can perform a chemical-based test to see if the head gasket is leaking. It’s worth the relatively small cost to rule this out and begin to look elsewhere.

Question 3

Are there known transmission problems with the 2015 Holden Cruze?

Accepted Answer

The most problematic of the Cruze transmissions were the six-speed automatic fitted to Cruzes built between 2011 and 2013. Holden actually instituted a special repair program for owners of these cars and extended the warranty period on those that had been repaired under the terms of that program. The 2015 car you’re looking at should not have these problems, but the Cruze itself was plague by a long list of other faults including oil and coolant leaks, overheating, cracked cylinder heads and more. To be fair, the later the build date, the less likely the problems were to occur, but any Cruze needs a careful, independent inspection before money changes hands.

Question 4

Can I put a 2010 Holden Cruze bootlid on a 2013 model

Accepted Answer

On the surface, the two bootlids look very much alike. In shape, they may well be identical, but there's a catch. In 2012, Holden switched from the fully-imported Cruze to a locally built version of the same car. Which means that the two versions were painted in completely different factories (different countries, in fact) and the chances of two blues or reds or even whites colour-matching exactly are pretty slim. If you look at the locally made Cruze line-up, you'll also see that many of the colours were shared with the Holden Commodore range (built in the same factory). The other thing to consider is that the paint on these cars was never stellar quality, and a decade or so of varying UV radiation exposure might mean that even two bootlids that started out the same colour, may not be now. Compare the two bootlids in strong sunlight to gauge whether the colours actually match before committing to the swap. That said, if you do manage to match two bootlids in an identical colour, it will be a lot cheaper than having one resprayed.

Question 5

2013 Holden Cruze engine is seeping oil

Accepted Answer

If the car in question has the 1.8-litre engine, then this is definitely a known problem. Plenty of these engines suffered cracked cylinder heads which could allow the engine's oil and coolant to mix, producing the symptoms you saw. Holden actually issued a service program to replace the cylinder heads and other components to address the problem. The other major cause of these symptoms is a failure of the transmission's cooling system. This actually piggy-backs on to the engine's cooling system (they use the same radiator) but if the transmission cooler fails, it can allow transmission fluid into the radiator and coolant into the transmission. Eventually, this will destroy the transmission both mechanically and electronically.

Question 6

What does error code P10171-00 mean?

Accepted Answer

This particular error code denotes a lean running condition. That is, the engine either has too little fuel or too much air entering it. It's actually quite common on this engine and can be traced to several possible causes. Some of those include bad fuel injectors, a worn fuel pump, an intake vacuum leak, or – and this is where we'd look first on this engine – a bad PCV valve. This valve is responsible for controlling the crankcase ventilation, but if it fails, it can allow the lean mixture condition to emerge which is when you'll get the error code and a check-engine light. The good news, is there's a quick and easy check if you know your way around an engine. First, remove the plastic engine cover to reveal the rocker cover and the PCV valve. With the engine running, place a small piece of paper over the hole in the PCV valve. If the paper is drawn to the valve, you have a leaking PCV valve probably due to a broken diaphragm which is allowing extra air to enter the engine and create the lean mixture. If that doesn't work, make sure the oil cap is fitted tightly as a loose cap can cause the same problem. This certainly isn't the case for all engines, but experience has shown that in your car, it's a good place to start. If the PCV valve theory doesn't work out, you're back to looking at things like fuel pressure, injector condition, intake tract leaks, a bad mass airflow meter or even a powertrain module fault. The knocking noise could be anything from a poorly secured spare tyre to the struts that hold the boot or hatch in the raised position.

Question 7

My 2013 Holden Cruze won't start or lock

Accepted Answer

It sounds as though you either have a problem with the car's electrics or the electronics within the ignition remote. If the car's battery is dead flat, you'll get the symptoms you're reporting, but if the remote has a flat battery (or is faulty in some other way) then you an find yourself in the same boat. But it could also be an electrical problem other than a flat battery. From memory, some of these Holdens had suspect battery terminals which lacked the grip they should have had and could lead to a loose connection which could produce these symptoms. This would be a good place to start. But there's another trick you can try. On some Cruze models, there's a process that can over-ride the remote locking and ignition protocols. If the battery in the remote is weak or the remote itself is damaged, this is definitely worth a try. From the driver's seat, locate the small, round plastic bung in the cup-holder in the centre-console. Place the remote key over this hole with the Holden logo facing up. Then try the starter button. With luck, the engine will start and you're away to have the remote fob fixed or replaced. You may find you need to hold the stop/start button for two seconds to get the engine to stop. Meantime, I have no idea why the actual physical key will not lock the doors from outside. That sounds more like a job for a locksmith.

Question 8

What is the best fuel for a 2014 Holden Cruze?

Accepted Answer

The 1.8-litre non-turbo and 1.4-litre turbocharged engines in the 2014 Cruze will run happily on 91-octane petrol. The more highly tuned 1.6-litre turbo engine in the SRi, SRi V and Z Series models required a minimum of 95-octane fuel. There's no problem using 95-octane fuel in the engines designed for 91 fuel, but you probably won't gain anything in terms of fuel consumption or performance. The only thing that will happen quicker will be the emptying of your wallet. There's no problem mixing 91 and 95-octane fuel in the cars designed to run on 91-octane petrol, but the 1.6-litre engine can be damaged by using anything other than a fuel with a minimum octane rating of 95.

Question 9

Holden Cruze Engine Oil: What Type & How to Change

Accepted Answer

The correct Holden Cruze oil type (grade) is a 5W30 fully synthetic. That’s for either the 1.8-litre, 1.4-litre turbo or the 1.6-litre turbo engine. The exception is the two-litre turbo-diesel Cruze engine which requires 5W40 grade oil. There are no real trade secrets on how to change oil on a Holden Cruze and, provided you have the right equipment and basic skills, it amounts to warming the engine, draining the oil from the sump into a container, replacement of the oil filter, replacing the drain plug, refilling the sump and making sure the oil in the engine is at the correct level. This is important maintenance because it ensures the engine always has a good supply of clean oil. Without this, the engine will die young. You can have a mechanic change your oil at a service centre, but with a drain pan, filter wrench, simple socket set and a work light, this is a DIY project. Things you’ll need to know include the size of the drain plug, the specifications (part number) of the oil filter, and how often to change oil on this particular engine (the service interval).

Question 10

What is the best fuel for my 2014 Holden Cruze?

Accepted Answer

The 1.8-litre non-turbo and 1.4-litre turbocharged engines in the 2014 Cruze will run happily on 91-octane petrol. The more highly tuned 1.6-litre turbo engine in the SRi, SRi V and Z Series models required a minimum of 95-octane fuel. There's no problem using 95-octane fuel in the engines designed for 91 fuel, but you probably won't gain anything in terms of fuel consumption or performance. The only thing that will happen quicker will be the emptying of your wallet. There's no problem mixing 91 and 95-octane fuel in the cars designed to run on 91-octane petrol, but the 1.6-litre engine can be damaged by using anything other than a fuel with a minimum octane rating of 95.

Holden Cruze 2011 Problems

Holden Cruze 2011: Common problems?

Used Holden Cruze review: 2011-2016

Holden Cruze 2011: Is a transmission replacement an improvement?

Transmission problem on 2011 Holden Cruze

Reliable secondhand small autos?

Transmission failure in 2011 Holden Cruze

Best small to medium diesel cars?

Should my 2011 Holden Cruze be experiencing this transmission issue?

Best first car options?

Holden Cruze: Signs of trouble

Search from Over 8,000 questions Over 8,000 questions answered by CarsGuide

Complete Guide to Holden
Cruze

Related cars for sale

cars

guide