Holden Isuzu FAQs

Check out real-world situations relating to the Holden here, particularly what our experts have to say about them.

• Can I swap a 2014 SRi motor into an SRi-V in my 2013 Holden Cruze?

  This is a slightly tricky one because while both the SRi and SRi-V were fitted with the same engine, this point in time marked a change in specification. Around March of 2013, Holden switched the SRi and SRi-V engines form the 1.4-litre unit to the 1.6-litre unit. The automatic transmission was updated with a sport-shift mode and predictive down shifting, although physically the automatic and manual transmissions were carried over to the 1.6-litre version.

  On the surface, this sounds like a viable swap, but you could run into wiring and computer problems in trying to make what was a 1.4-litre car `talk’ to the 1.6-litre engine. The 1.6-litre engine also used direct fuel injection, so you’d need the entire engine management system and computer to go with the swap. There may also be physical differences in things like airbox design and exhaust locations, too, so you need to drag out the tape measure and make an assessment based on measurements and facts. However, if your 2013 car was one from later in that year, it will already have the 1.6-litre engine and the swap to an engine from a 2014 car should be pretty straightforward.

  Show more Show less
• Having crankcase ventilation valve problems with my 2015 Holden Astra

  Having a bolt snap off while you’re undoing it is a royal pain and can bring take the car off the road if it’s a critical fastener. You’re probably best off visiting a mechanical engineering shop (or good workshop) who will have the tools necessary to remove the broken chunk of bolt still lodged in the car.

  Techniques vary according to how much bolt is still showing, access to it and even what it’s made from. In some cases, the engineer will use what’s called a bolt-extractor kit which screws into the broken bolt and extracts it without damaging the existing threads. If you’re lucky there will still be enough of the broken bolt exposed to allow the use of vice-grips to remove it. Sometimes a small section of new metal can be welded to the broken stud or bolt to give purchase and in extreme cases there’s even a process called spark eroding which is more expensive but can really save the day. The last resort is usually drilling the broken bolt out as this can destroy the threads in the part, requiring even more work to ultimately replace the fastener. In each case, penetrating fluid and/or the application of heat will be the first step to try to free or loosen the broken fastener before trying to extract it.

  Show more Show less
• My 2010 Holden Barina won't go in to first or fifth gear

  Losing particular gears can be a symptom of internal transmission damage, but it can also indicate a simpler problem with the selector mechanism that joins the gear stick to the gearbox. However, if this was the case, you’d probably lose two gears on the same selector plane (such as first and second or third and fourth) not first and fifth which are at opposite ends of the shifter mechanism.

  If there was internal gearbox damage, you’d possibly also be noting other noises and problems caused by the internal carnage, which makes me think the internal selector mechanism might be at fault. At which point, it’s probably a gearbox-out repair.

  However, a transmission specialist that knows this gearbox well may have a different opinion and should be your first port of call. A specialist will save you time and money in the long run.

  Show more Show less