Hyundai Trajet FAQs

Check out real-world situations relating to the Hyundai here, particularly what our experts have to say about them.

• The dipstick is blowing out in my 2022 Hyundai Tucson diesel

  It sounds very much like there’s a blow-by problem with this engine. The pressure created by the combustion process is somehow getting past the pistons and into the crankcase, causing the dipstick to leave its tube and blowing oil all around the engine bay.

  Blow-by is often caused by worn or broken piston rings or a damaged piston itself. But modern turbo-diesels are also prone to problems with their crankcase ventilation and emissions-control systems which can become full of gunk and not allow the crankcase to breathe properly. At which point, the same symptoms can occur.

  A mechanic will be able to do some tests and determine what’s causing the pressure build-up inside the crankcase. If it’s internal wear, a rebuild may be required. But if it’s a build-up of crud inside the emissions-control systems, a manual disassembly and clean might be required. Either way, your car’s warranty might cover you for this, so the Hyundai dealer is your first port of call.

  Show more Show less
• Total gearbox failure in a 2017 Hyundai Accent automatic

  Car makers will sometimes help out with such problems provided the car has been serviced correctly and not abused throughout its life. I agree that 40,000km is not a reasonable expectation for a modern automatic transmission, so I’d be contacting Hyundai Australia’s customer service division to see if anything can be done. Experience tells me that Hyundai takes its obligations in this area pretty seriously, so you may be offered some help with the cost of repairs.

  You could also have the transmission inspected to see what went wrong (your state motoring club is a good place to start for independent inspections like this one) as this information might be very useful if you decide to take the matter further. The ACCC would be the final step in this process, and Australian Consumer Law deals with what is fit for purpose and what is not.

  Show more Show less
• Why has my 2019 Hyundai Kona been losing power?

  I can understand why the crank angle sensor was the first thing to be changed. These often start to die and the first symptom is an engine that stops after running for a while. But you’re right to be sceptical about the timing chain as there’s a theory that says if the engine runs properly at all, then the issue won’t be anything fundamental. Which is to say, if the timing chain was stretched beyond the point at which the engine could function properly, it wouldn’t function properly at all, regardless of how long it had been running.

  A good workshop should be able to scan the car’s computer. If the timing chain really is stretched, then the computer should have logged this as a problem. If not, then you’re looking for something else. Of course, what that something else is the million-dollar question. Don’t rule out basic things like a dirty fuel filter which can allow fuel to flow for a while before the rubbish in it clogs the flow after a few minutes running.

  That said, if the engine can’t locate the correct signal from the camshaft (which is controlled by the timing chain) it will sometimes look for a stand-in signal somewhere else on the engine, allowing it to start but not run properly. An electronic scan is definitely the way forward.

  Show more Show less