Holden Barina 2017

Holden Barina 2017 Q&As

Check out real-world situations relating to the Holden Barina here, particularly what our experts have to say about them.

• 2014 Holden Barina won't select reverse

  Based purely on your symptoms, a broken clutch is the most likely cause. When a clutch loses the ability to fully disengage the engine from the transmission (through either wear or damage) the gears can become very difficult to select. Sometimes they will engage with a crunch, at other times you may not be able to select them at all.

  This is a different problem to a worn clutch which has lost its clamping ability and is slipping, but the ultimate fix is the same: A new clutch assembly.

  Show more Show less
• Why is my 2007 Holden Barina dropping dead while driving?

  The thing with problems like these is that you could be looking at a single fault or a group of problems that are each giving you a different symptom. Something could be getting hot in the engine management system that is causing the vehicle to shut down, and a good place to start looking would be the crank-angle sensor. When these get hot, they stop sending a critical signal to the engine’s computer and it just shuts down. After a short cool-down period, the sensor can often come back to life and away you go again.

  Meantime, a stuttering idle and inconsistent engine speed on start-up would make a lot of mechanics check out the stepper motor which is part of the throttle mechanism and is responsible for setting the idle speed and allowing the engine to start.

  Has your mechanic scanned the car or simply done a few basic checks? An electronic scan should be your next step if it hasn’t already been done.

  Show more Show less
• My 2010 Holden Barina won't go in to first or fifth gear

  Losing particular gears can be a symptom of internal transmission damage, but it can also indicate a simpler problem with the selector mechanism that joins the gear stick to the gearbox. However, if this was the case, you’d probably lose two gears on the same selector plane (such as first and second or third and fourth) not first and fifth which are at opposite ends of the shifter mechanism.

  If there was internal gearbox damage, you’d possibly also be noting other noises and problems caused by the internal carnage, which makes me think the internal selector mechanism might be at fault. At which point, it’s probably a gearbox-out repair.

  However, a transmission specialist that knows this gearbox well may have a different opinion and should be your first port of call. A specialist will save you time and money in the long run.

  Show more Show less
• My 2018 Holden Barina is misfiring

  What make you think it’s the MAF (Mass Air Flow) sensor? If you’ve simply googled the symptoms and found a forum that suggests the MAF sensor, be very careful. These forums are not universally populated by people who have the first idea of what they’re talking about. True, some forums are great and wise, but simply pulling an answer out of a hat without even seeing the car is a road to nowhere in many cases.

  It's also why the advice we’d have to give is to have the car looked at by a professional who will probably start by electronically scanning the car to see what fault codes have been logged by the computer. It’s possible the MAF sensor is, indeed, the problem, but it could also be about a thousand other things that need to be ruled out before you start spending money on new parts that may or may not solve your problem. The fact is, these symptoms could be anything from a dud spark plug to a loose wire, either of which would cost a lot less to fix than fitting a new MAF sensor.

  Show more Show less