Question 1

My 2010 Holden Barina won't go in to first or fifth gear

Accepted Answer

Losing particular gears can be a symptom of internal transmission damage, but it can also indicate a simpler problem with the selector mechanism that joins the gear stick to the gearbox. However, if this was the case, you’d probably lose two gears on the same selector plane (such as first and second or third and fourth) not first and fifth which are at opposite ends of the shifter mechanism. If there was internal gearbox damage, you’d possibly also be noting other noises and problems caused by the internal carnage, which makes me think the internal selector mechanism might be at fault. At which point, it’s probably a gearbox-out repair. However, a transmission specialist that knows this gearbox well may have a different opinion and should be your first port of call. A specialist will save you time and money in the long run.

Question 2

My 2018 Holden Barina is misfiring

Accepted Answer

What make you think it’s the MAF (Mass Air Flow) sensor? If you’ve simply googled the symptoms and found a forum that suggests the MAF sensor, be very careful. These forums are not universally populated by people who have the first idea of what they’re talking about. True, some forums are great and wise, but simply pulling an answer out of a hat without even seeing the car is a road to nowhere in many cases. It's also why the advice we’d have to give is to have the car looked at by a professional who will probably start by electronically scanning the car to see what fault codes have been logged by the computer. It’s possible the MAF sensor is, indeed, the problem, but it could also be about a thousand other things that need to be ruled out before you start spending money on new parts that may or may not solve your problem. The fact is, these symptoms could be anything from a dud spark plug to a loose wire, either of which would cost a lot less to fix than fitting a new MAF sensor.

Question 3

How long until I can expect issues with a 2014 Holden Barina?

Accepted Answer

There’s no hard and fast rule on this stuff, and the lifespan of a car will depend heavily on how it’s been serviced. Any car that has been ignored and abused will have a shorter run than the same make and model that has been meticulously maintained and serviced. And this difference can literally be hundreds of thousands of kilometres. However, it’s also worth keeping in mind that this model Barina was a Daewoo by any other name (and not a particularly good one, at that) and was designed and engineered as such. Even a well maintained example is probably going to be getting pretty long in the tooth by the time 200,000km have been clocked up. Common faults include dramas with the engine and transmission and many owners simply find that the cost of repairs is more than the value of the vehicle itself. At which point they get scrapped and recycled.

Question 4

Should I buy a 2014 CD Barina automatic with 33,000km on the clock?

Accepted Answer

That price is towards the top end of things for this particular make and model, but within reason given the low kilometres on the odometer. Make sure it has a full service record as, even though it hasn’t been used much, it will still have needed proper servicing if it’s to remain reliable.

Question 5

Oil is mixing with coolant in my 2015 Holden Barina

Accepted Answer

This is not a good sign and suggests that you have a fairly major engine problem. Sometimes this can be caused by an automatic transmission’s oil cooler having split and emptying transmission fluid (oil) into the radiator’s coolant. If that’s the case, the transmission will also probably be damaged both mechanically and electronically. Other causes are a catastrophic failure of the engine crankcase or – not quite as serious – a blown cylinder head gasket. But in either of these cases, the engine will need major repairs. The cost of which may exceed the actual value of the car. Depending on the severity of the problem, a recycled, second-hand engine from a wrecked Barina of the same model might be a better option.

Question 6

2008 Holden Barina dropping out of gear

Accepted Answer

A manual car that jumps out of gear is usually a case of a worn gearbox. As the internals and gear selectors wear over time, they become loose, allowing the vehicle to jump into neutral. The first check would be to see that the external linkage to the gearbox (a cable in the Barina’s case) is correctly adjusted and not about to fall apart. If that’s the case, you might find that the selector is not fully engaging each gear, and that’s why it’s jumping out of that gear. But beyond that, the problem is likely to be caused by wear inside the mechanical bits of the transmission.

Question 7

Why can I smell coolant burning when my 2015 Holden Barina gets hot?

Accepted Answer

First things first: If you can smell coolant when the engine is warmed up (or any other time) then you have a leak somewhere. Coolant leaks can be hard to spot as they are not always large and are often located in weird, hard to see places. But if you can smell it, it’s escaping the cooling system somewhere and you need to locate it and fix it. If you have a slow leak, it’s possible you could drive for weeks without the car overheating, but eventually the engine will start to notice the low coolant level and run hotter as a result. Get it fixed now before you damage the engine. You should be fine to use a bit of tap-water (which will dilute the coolant in the rest of the system) until the leak is found, but don’t leave tap-water (or an incorrect or diluted mixture of water and coolant) in the radiator for the long term. As for the brakes, the problem does, indeed, sound like warped rotors. Sometimes these can be machined back to true, but often they need to be replaced. Either way, replacing the brake pads at the same time is best practice. Worn pads on new rotors can make those nice, new rotors wear faster than they should.

Question 8

I'm having rev problems with my 2006 Holden Barina

Accepted Answer

First thoughts are that the stepper-motor (which controls the idle speed) is faulty. That would explain both the high idle at low engine temps and the stalling and stumbling as you roll to a stop. This component is really just a small electric motor and shouldn't be too expensive to replace. But have the car scanned first to make sure there are no other obvious causes for this behaviour. A faulty engine temperature sensor or some other small component could also produce these symptoms.

Question 9

Temperature warning light and buzzer coming on in 2016 Holden Barina RS

Accepted Answer

The first thing to determine is whether the engine is actually getting hot. You need to find a mechanic who can tell the difference between a genuinely hot engine and one that is crying wolf. Most times, this will involve letting the engine idle until the warning light comes on and then checking the actual temperature of the coolant. This is usually done via a trusted thermometer (infra-red thermometers are great for this) checking the temperature of the coolant in the radiator's top tank. If the engine really is hot, then you're looking for a mechanical problem. But if the temperature is within a normal range, then you need to start looking for a dud temperature sensor, faulty gauge/light or a problem with the car's wiring. This can be a lot harder to find than you might think, but driving around with a temperature warning flashing is no good either.

Question 10

Is it normal for the thread on my Holden Barina 2013's sump oil pan to start disintegrating?

Accepted Answer

It won't be the sump itself disintegrating, but my guess is that somebody who has changed the oil in the past has over-tightened the drain plug when they've replaced it. That stretches the threads on what is often a relatively soft metal and, as a result, the threads have broken away from the rest of the oil pan as you've tightened the plug. This is actually more common than you think and happens because people don't stop to think about how much force they use when they replace the plug. While it's true that you don't want the plug undoing itself while you're driving, it's also the case that all that sump plug has to do is keep the oil inside the engine. It serves no other purpose and simply doesn't need to be too tight. Sometimes, home mechanics ignore the need to replace the crush washer on this plug with the result that they then notice an oil a leak a few days later. That's when they'll reach for the big spanner and try to tighten the sump plug some more to stop the leak. And that's when the threads break away and they're in the position you now find yourself. The solution is to get the vehicle to a workshop (you may have to tow it as it can't be driven with no oil in the engine) which should be able to drill the hole in the sump to the next over-size and fit a slightly larger, new sump plug. It's tricky though, as you don't want to allow swarf (little metal filings from the drilling process) into the engine where they'll damage those expensive internal parts.

Holden Barina 2005 Problems

Used Holden Barina review: 2005-2016

Holden Barina 2005: Should I follow my mechanic's advice or the service book?

Holden Barina 2005: Needs frequent water checks?

Used Holden Barina review: 1989-2012

Used Holden Barina review: 2005-2008

Holden Barina 2005: Linkage kit installation?

Search from Over 8,000 questions Over 8,000 questions answered by CarsGuide

Complete Guide to Holden
Barina

Related cars for sale

cars

guide