Holden Colorado 2016 Problems

No car is perfect, but we've gathered everything relating to the Holden Colorado 2016 reliability here to help you decide if it's a smart buy.

My 2016 Holden Colorado is crunching gears

Answered by CarsGuide 17 Jun 2025

Manual gearboxes generally work better/more smoothly when they have some heat in them and the oil gets a little thinner and better able to lubricate. So you’re right on that account. If the gearbox was crunching on every gearchange, you’d also probably suspect the clutch might be worn, too. But since it’s only the one gearchange that’s making the noise, then your theory that the synchromesh rings are worn holds water.

But before you do anything drastic, make absolutely sure the clutch is disengaging fully and that all the clutch lines and pedal action are spot on. A dodgy clutch can also produce this sort of crunching noise. And, yes, it can be worse when the vehicle is cold.

Meanwhile, for some reason, the synchromesh on second gear is the one most likely to fail on the majority of cars (probably because second gear cops and awful hiding and copes with very high loads). So, in that sense, yours is a copy-book case of worn synchros. (First gear is also highly loaded, but since you only really shift up from first – hardly ever down to first on the move – its synchromesh rings don’t cop such a spanking.)

If the problem gets worse, you’ll probably find the upshift from first to second will also start to graunch. That’s when you’ll know for sure that the synchros need replacing. As you point out, though, to really diagnose this the fault requires an inspection of the parts and that means the gearbox out and pulled apart. While you’re in there, change the other synchromesh rings and the transmission’s bearings. And don’t put it back together without a new clutch.

In the meantime, however, if you’re prepared to shift very slowly and carefully while the vehicle is cold, you can actually drive around this problem. Many car owners have done so for years without further problems. Not best engineering practice, perhaps, but it’s a money saver.

Show More

The steering shaft lower spline to steering rack in my 2016 Holden Colorado RG7 Trailblazer is loose

Answered by CarsGuide 6 May 2024

You really can’t afford to take any chances with a car’s steering system. The thought of this crucial system failing even at low speeds doesn’t bear thinking about, so if there’s any play or looseness in the system, it needs to be diagnosed and fixed properly with new parts if necessary.

Meantime, Loctite and other thread-locking products are designed to stop fasteners coming loose. These products are not designed to take up slack in worn parts and shouldn’t be used that way. Even if the thread-locker stops the fastening nut coming loose, it won’t do anything about the slack in the joint you’ve already noted.

Show More

Best vehicle for towing a horse float?

Answered by CarsGuide 5 Feb 2016

You need to know the all-up weight of the trailer with the three horses all your gear aboard. The horses alone weight 1500 kg, and the float is going to be 1500 to 2000 kg, so you need a vehicle capable of towing 3500 kg. There are a number on the market rated to tow that load, vehicles like the Holden Colorado, Mazda BT-50, Ford Ranger, Land Rover Discovery etc. You also need to be mindful of the Gross Combination Mass of the vehicle when you're going to tow at or near its maximum rating to ensure you don't exceed it.

Show More

Over 8,000 questions answered by CarsGuide

Search
Disclaimer: You acknowledge and agree that all answers are provided as a general guide only and should not be relied upon as bespoke advice. Carsguide is not liable for the accuracy of any information provided in the answers.

Complete Guide to Holden
Colorado

Reviews, price, specs and more