Question 1

Low voltage in my 2014 Mazda BT-50 GT battery is causing transmission problems

Accepted Answer

Modern cars absolutely hate having low battery voltage. It throws everything into chaos and can easily produce the sort of problems you’re having as the major components of a car are, these days, all controlled by computers. By turning the car off and on again, you’re effectively performing the old Alt-Ctrl-Del function to reboot a home computer or laptop. As such, and especially since the transmission works perfectly when you reset it, this is almost certainly an electrical problem. A more permanent reset might be needed, so try leaving the battery disconnected overnight and then reconnect it next morning. This will often return things to normal.

Question 2

What causes oil to leak from the gearbox in a 2016 Mazda BT-50 3.2 diesel?

Accepted Answer

First things first: are you sure the leak is coming from the gearbox and not the engine? It can be very hard to discern the difference in a manual car, although it’s easier in an automatic as the transmission fluid is usually a red colour. Beyond that, oil can escape from a gearbox through a variety of places. The breather could be allowing fluid out, the pan seal could be leaking, the rear gearbox seal could be faulty or you could even have a cracked transmission casing. Don’t rule out a leaking drain plug, either, as this is a very common source of a leak. You might even find the leak is coming from somewhere within the transmission cooler and its plumbing.

Question 3

2022 Mazda BT-50 with faulty steering geometry

Accepted Answer

It’s a bit hard to know what’s going on here. If a tyre is scrubbing on its inside edge, it’s often a problem with the camber settings (the amount of lean on the tyre from top to bottom). If it was realigned incorrectly, it’s conceivable that too much camber was removed and now the opposite problem is occurring where the outside edge is wearing too quickly. That said, sometimes incorrect toe-in and toe-out settings can cause similarly odd tyre wear. Either way, this sort of problem should not be beyond the skills of a wheel alignment specialist to rectify without any mechanical changes to the vehicle or its suspension. In extreme cases, adjustable suspension bushes or mounting points can be fitted in place of the standard items to provide a greater range of adjustment. You may find that rectification is warranty issue, but if the misalignment came about through wear and tear or hitting a pothole or big bump, then it may not be covered by the factory warranty. Previous crash damage that has not ben repaired properly is also another common cause of weird tyre wear due to poor wheel alignment.

Question 4

Why does my 2017 Mazda BT-50 go into limp mode while towing my 21-foot caravan?

Accepted Answer

It mightn’t seem like the vehicle is struggling, but when you consider that a caravan of this size can easily weight the best part of three tonnes, you can see how it puts a strain on every component of the vehicle towing it. It sometimes only takes a small hill or a headwind to push a towing vehicle into its discomfort zone. Do that long enough and eventually something will get hot enough to trigger the limp-home response. But don’t rule out a check-up at a BT-50 or Ford Ranger (they’re the same vehicle under the skin) specialist who should be able to pinpoint the weak link, as well as offer solutions to stop it happening again. You might find you need a bigger transmission or engine oil cooler, or even a retune of the engine to bring it back to tip-top shape. Accessories you’ve added can also make a difference. Have you, for instance, fitted a roof rack or larger wheels and tyres? A roof rack can add a lot of aero drag that has to be overcome, while bigger tyres can mess up the vehicle’s gearing, causing it to work harder for the same road speed as before.

Question 5

Why does my 2011 Mazda BT-50 turbo-diesel lose power at 2200rpm?

Accepted Answer

On the surface, you’d probably start looking at the car’s fuel system. A diesel, even a modern one, is controlled largely by how much fuel is being pumped into it and at what pressure. If the fuel pump is slack or the injectors, filters or lines are faulty or leaking, you might find that there’s simply not enough fuel to keep it revving on beyond that 2200rpm. But you could also be looking at an exhaust problem, a partially blocked intake system, dirty air filter, or even a worn out turbocharger. A mechanic who is familiar with this make and model is going to have the best chance of diagnosing what’s wrong. Chances are yours is not the first vehicle to do this, and a specialist mechanic has possibly seen it all before.

Question 6

Powertrain warning light coming on in my 2016 Mazda BT-50 manual

Accepted Answer

A powertrain warning light can be triggered for literally hundreds of reasons. So there’s no point trying to guess what’s wrong here. Instead, have the vehicle electronically scanned at a workshop and see if the on-board computer can shed any light on what components or systems are at fault. Theoretically, the computer should have logged the cause each time the warning light has flashed on. During a scan, these faults will show up as a series of fault codes which the mechanic will be able to decipher to get a good idea of what’s wrong. Without this information, you could be chasing up blind alleys for weeks and months. The other thing you can do is make a note of what the vehicle is doing when the light comes on. For instance, if the warning light flicks on when you’re towing, you may have a driveline overheating issue.

Question 7

How can I tell what series or model my Mazda BT-50 ute is?

Accepted Answer

Here’s the simple test. Does the vehicle have a body coloured front bumper-bar and chrome exterior door handles and mirrors? If it does, it’s an XTR. If not, it’s an XT.

Question 8

Squeaking at low speed in a 2014 Mazda BT-50

Accepted Answer

A squeak when taking off from rest could be anything from a brake problem to a wheel bearing fault, a noisy engine drive-belt, bent axle, a dry suspension bush, worn universal joint or just about a hundred other things, including the driveshaft you already suspect. Of potentially greater concern is the cut-off exhaust system or, more correctly, the previous owner. Anybody who cuts up an exhaust to make more noise is also a likely candidate to have driven the vehicle hard. It might be better to find a vehicle that hasn’t been messed with and potentially abused. A sawn-off exhaust system shouldn’t harm the turbocharger or engine, but it can make a difference to performance due to reduced back-pressure. It also makes me wonder what else has been changed of fiddled with in the name of more power. Sometimes the performance will actually be improved, but you also open a can of legal and insurance worms by changing things like factory exhaust systems in what is a fairly agricultural way.

Question 9

Where is the transmission oil dipstick in a 2018 Mazda BT-50?

Accepted Answer

A lot of modern transmissions don’t have a dipstick at all, particularly as manufacturers move towards transmissions that have very long service intervals and are considered sealed systems. Which is fine until it’s not. And that’s when you need to check the level and condition of the transmission fluid. The good news is that the BT-50 in question does have a dipstick. The bad news is that’s mighty difficult to get to. You need to be under the car (so safety is the key here) and then locate a 19mm fitting on the driver’s side of the transmission. By unscrewing this fitting, you can withdraw the dipstick and check the level. The other catch is that you need to do this with the engine running (to get an accurate reading) and the dipstick is located close to what will therefore be a hot exhaust system. All of this means it’s really a job for a specialist with a hoist and is a great example of a carmaker saving a few cents per car in production at the expense of the greater running costs for the owner over the life of the vehicle.

Question 10

Does fuel consumption on a brand new 2024 Mazda BT-50 improve?

Accepted Answer

The fact that the fuel economy average seems to be creeping up can have a lot to do with the fact that you’re becoming more familiar with the vehicle and using more throttle as a result. But remember, too, that until you reset the average on the trip computer, what you’re seeing is the full history of your consumption from when the trip computer was last zeroed, not just the most recent trip you’ve done. It's true that engines often start to use a little less fuel as they 'bed in’ after a few thousand kilometres. And for a modern turbo-diesel like yours, I reckon 10,000km or even 15,000km might be the magic number. However, don’t be too disappointed if it doesn’t come down a whole lot. I reckon for that vehicle, driven the way you’ve described, 10 or 11 litres per 100km isn’t a bad average to aim for. Other factors play a big part, too. Does the vehicle have a bull-bar or roof racks? Both these add weight and aerodynamic drag respectively, and can easily make the car consume more fuel. A roof rack at 100km/h can be worth an extra litre per 100km.

Mazda BT-50 2008 Problems

2008 Mazda BT-50 overheating

What's wrong with my seatbelt?

BMW, Mazda, FCA, Citroen and Peugeot models recalled

Deadly Takata airbag recall nears 1.2 million in Australia

Used Mazda BT-50 review: 2006-2009

Search from Over 8,000 questions Over 8,000 questions answered by CarsGuide

Complete Guide to Mazda
BT-50

Related cars for sale

cars

guide